返回列表 發帖

20vt stainless steel manifold

http://cgi.ebay.co.uk/Fiat-Coupe ... ehicles_CarParts_SM

Big brothers, I will need to source for a new manifold... is this one good value? Or is there any other supplier that I can contact?

http://forum.hkfiatclub.com/view ... page%3D9&page=1

Is it the same supplier as Letsrock's!?

TOP

Seems like it is the same guy on ebay.   Get the one with coating.  250 is a fair price.

TOP

造工真係唔算係巧手貨, 不過, 只要可以平平地執返好再安裝到上去,check過無揩到其他野, 好彩又無漏氣, 加少少心機包一包蕉皮, 又配到stud螺絲, 再準備好gasket.
咁....你就可能放心用喇...
逢星期日...糕-糕-糕.

TOP

Simon, you reckon that the 蕉皮 is still needed even with the coating?

TOP

oo. you are right, no need 蕉皮 when using 瓦煲.
逢星期日...糕-糕-糕.

TOP

do not like the look of the ss manifold.

TOP

回復 7# Eric

becox this is not from Japs??? kaka

TOP

Has your existing banana cracked?  If so, just ask the garage to arrange for wielding laa, it is a lot cheaper than getting a SS manifold for the 20vt, this is not a performance upgrade kit as it is not an equal length exhaust manifold like the 16vt ones.  You probably saves 1 or 2 kg but no much more than that.  

Oh yes, I am a Cheap Ass!

TOP

Mine SS manifold is still in Arvin's place... .Don't know the performance / fitting is good or not yet.....

TOP

Performance will be dragged down at the low rev and cold engine, also due to the nature of SS, the manifold might become loose due to extreme temp changes.

TOP

Performance will be dragged down at the low rev and cold engine, also due to the nature of SS, the m ...
letsrock 發表於 2010-8-26 11:37

I should then use my Iron manifold until it cracks again...

TOP

我對條蕉無投訴, 不過我對氐個生產商的產品有好大反感.
所以, 我唔建議再向呢一個supplier買蕉.
逢星期日...糕-糕-糕.

TOP

返回列表