Coupe - add or remove keys to CODE system

AbarthJoe

http://www.fccuk.org/forum/ubbth ... &Number=1285182

2 blue keys with each with different CODE identities
Your red key.

Next thing is to do key learning. This takes a few minutes. You put the red key in, turn to a particular ignition position for about 20 secs, then remove the red key, put the first blue key in, then the second blue key, then finish off with the red key again.

真的嗎？ 有無人試過?

AbarthJoe

http://www.fccuk.org/forum/ubbth ... t&Number=169301

I want to add or remove keys to my CODE system

You must have a red key for this procedure. If you encounter a problem whereby your silver or blue key is no longer working and the CODE light says on, you want to add a new key to the code system or you want to remove a key you have lost, use the procedure below.

    * Have all your keys to hand.
    * Insert Red Key and turn to MAR (ignition on, but do not start the engine) until CODE disappears. Remove red key.
    * Insert Silver Key, turn to Mar until CODE goes out, remove silver key.
    * Insert Blue Key, turn to Mar until CODE disappears, remove blue key.
    * Insert Red Key, turn to MAR until CODE disappears. Remove red key.


You should now have all your keys CODE's stored in the car, and will be able to start with any of them. Any keys that have not been included in the sequence will now no longer start the car, the engine will turn but the code light will stay light and the car will not fire.

古惑強

Yes, the program sequence does works.