Board logo

標題: 20vt stainless steel manifold [打印本頁]

作者: Trevor    時間: 2010-8-25 23:40     標題: 20vt stainless steel manifold

http://cgi.ebay.co.uk/Fiat-Coupe ... ehicles_CarParts_SM

Big brothers, I will need to source for a new manifold... is this one good value? Or is there any other supplier that I can contact?
作者: Trevor    時間: 2010-8-25 23:58

http://forum.hkfiatclub.com/view ... page%3D9&page=1

Is it the same supplier as Letsrock's!?
作者: letsrock    時間: 2010-8-26 06:59

Seems like it is the same guy on ebay.   Get the one with coating.  250 is a fair price.
作者: Simon    時間: 2010-8-26 07:14

造工真係唔算係巧手貨, 不過, 只要可以平平地執返好再安裝到上去,check過無揩到其他野, 好彩又無漏氣, 加少少心機包一包蕉皮, 又配到stud螺絲, 再準備好gasket.
咁....你就可能放心用喇...
作者: letsrock    時間: 2010-8-26 08:10

Simon, you reckon that the 蕉皮 is still needed even with the coating?
作者: Simon    時間: 2010-8-26 09:12

oo. you are right, no need 蕉皮 when using 瓦煲.
作者: Eric    時間: 2010-8-26 09:17

do not like the look of the ss manifold.
作者: greenbug    時間: 2010-8-26 09:20

回復 7# Eric

becox this is not from Japs??? kaka
作者: 古惑強    時間: 2010-8-26 10:42

Has your existing banana cracked?  If so, just ask the garage to arrange for wielding laa, it is a lot cheaper than getting a SS manifold for the 20vt, this is not a performance upgrade kit as it is not an equal length exhaust manifold like the 16vt ones.  You probably saves 1 or 2 kg but no much more than that.  

Oh yes, I am a Cheap Ass!
作者: coupeelvin    時間: 2010-8-26 11:36

Mine SS manifold is still in Arvin's place... .Don't know the performance / fitting is good or not yet.....
作者: letsrock    時間: 2010-8-26 11:37

Performance will be dragged down at the low rev and cold engine, also due to the nature of SS, the manifold might become loose due to extreme temp changes.
作者: coupeelvin    時間: 2010-8-26 14:17

Performance will be dragged down at the low rev and cold engine, also due to the nature of SS, the m ...
letsrock 發表於 2010-8-26 11:37

I should then use my Iron manifold until it cracks again...
作者: Simon    時間: 2010-8-26 14:35

我對條蕉無投訴, 不過我對氐個生產商的產品有好大反感.
所以, 我唔建議再向呢一個supplier買蕉.




歡迎光臨 香港快意討論區 (http://forum.hkfiatclub.com/) Powered by Discuz! 7.2