Why not ?? Actually faster than Ni-MH....According from my friend info ...LiPo can use 10A current to charge .....25-30 mins fully charge the 6000mah ....Moreover , 10A to charge ...the battery performance totally difference with lower current ....作者: greenbug 時間: 2011-5-12 11:54
but the many ppl suggested use Balance charge wooooo, so which 1 should be better le?作者: raypoon 時間: 2011-5-12 11:57
Sure , "MUST" use Balance charge mode....balance charge also can fast ....
If you using the Imax B6 charger ....you can see the current drop to below 1.5 A even you select the 5A to charge ....
WHY?? Coz the Imax B6 charger starting to balance around 4.0 V to 4.1 V per cell ....so , if one cell fully charged to 4.2V and the other cell still below 4.2V.....what the charger will do ??? discharge the 4.2V cell to bit lower V and recharge again ......again and again ....so , you may spend around 2 hours to charge a 5500ma LIPO.....---__---""
so ,what difference of expensive charger.....?? The balance mode started once you press "START" button ..... 2 cell in very close V. all time .... so ,2 cells very easy fully charge to 4.2V at the same time .....thats why I decided to invest.....作者: 佐治仔 時間: 2011-5-12 12:02
UNA6 is on my list before, it is great that using separate channel to charge individual cell, it is much better then the normal balancing charge. Old way balancing is keep on discharge on those full cell until all cells become fully charged. But UNA6 charge each cell individually, so it can stop when cell full but keep on charging other cell which is not full.