Nice MX-5 (Mk II) wheels

古惑強

http://www.28car.com/par_dsp.php?h_vw=y&h_id=74924



To bad that the Mazda hub is 54mm, ours are 58mm,  impossible to fit!  Otherwise I think it will look quite nice on either the Coupe or Bravo.

Jason16VT

Making a spacer to convert the bolt distance and hub size is possible.

古惑強

When need +20mm hub spacer converter to have sufficient strength to hold the different hub size, I don't think it is worth the effort

But these wheels sure look very nice!

Jason16VT

If you design the spacer correctly, you do not need a +20mm spacer, +12mm to +15mm should be enough.

古惑強

Nope, can't be done in this occasion with less than 20mm spacer, the reason as follows :

1. The wheel bore of the Mazda is 54mm
2. The hub bore of Fiat is 58mm.
3. The Spacer with the side attaching to the hub will need 58mm centre space, the spacer must be quite thick materials to clear the Fiat hub bore while left with sufficient remaining materials to maintain the strength of the outer lip of the 54mm to fit the Mazda wheel.  Using 15mm thickness will not have sufficient material for the required strength.