如何拆Coupe尾避震機

Simon

Copied from FCCUK forum

they are a doddle to change, im sure there was a guide somewhere , anyway here is my guide !

I fitted konis but the method is the same -

Rears -
jack up remove wheel

remove the bottom damper holding down bolt

remove the botom spring cup holding down nut 6mm underneath spring.

no need to compress no tension in.

use bar to give spring a shove out.

remove magic grommets in wheel arch to reveal the top damper bolt.

shove in carrier bag into box section where you have just taken grommet out off in case you drop anything. 呢個建議幾好.

undo top damper bolt retrieve bolt careful not too drop it you will need long socket,damper will drop to floor

set koni damper i set in the middle.(medium)

refit top damper bolt and new koni damper

attach rubber spring cups to new spring,you should be able to just shove in without compressors

fit bottom damper bolt

wheel back on.


Edited by sprintsteve (08/04/2009 19:32)

Simon

最危險的一粒螺絲, 分分鐘跌落去個擔入面永永遠遠講bye bye, 一係就攞出工具時, 跌個15號box入去.
好好好好小心先得, 安裝時, 放返螺絲入去時, 可用膠紙纏住, 唔怕跌.